Sasquatch

ETC Sensors have a unique technology embedded in them called Geomagnetic Sensing that monitors the Earth’s magnetic field in real time and then reacts to anomalies caused by ferrous metals found in plungers. By connecting Vision, we can see the changes to the magnetic field in real time. What You…

There are a number of common problems that can happen when trying to use Modbus with the ALiEn2 or Sasquatch. Please check each of the sections below. Is Modbus enabled? For the ALiEn2, Modbus is diabled by default to save power. Press install Navigate down to Modbus and press select.

ETC sensors are used in a number of different geographical locations with different standards for wire and connector. As well, in some cases, the cable must be sealed to prevent the propagation of gas. For these reasons, we have chosen not to include a wiring kit with a connector.

Vision Device Management can connect to a physical controller using a serial port or to the simulator using TCP. The pre-configured SCADA Server allows a user to interact with the controller by reading or writing settings. What You Need Before planning to interact using Modbus, you should make sure you…

ETC plunger sensors have a bootloader and separate firmware image that is used when it comes to programming them with a new version of software. This allows users to erase the firmware and replace it with a newer version or a release with a different feature set. What You Need…

All of the certification certificates and control drawings for ETC products can be found on their product page. Click on the links below to go to the appropriate page: