ALiEn2

ETC plunger lift controller enclosures are pre-punched to accommodate both single valve solenoids and dual valve solenoid assemblies. A dual valve solenoid assembly comes with two (2) solenoids connected together with a pre-installed tee. To purchase replacement parts, please contact an Authorized Reseller. For more information, please visit our FAQ….

Load factor is a built in feature that allows you to open the well based on it’s ability to lift the fluid at the bottom of the well bore. What is Load Factor? Load Factor is the ratio of Fluid Pressure to Lift Pressure which is used to determine when…

All pressure inputs work generally the same way. This article discusses how to install, enable, and configure pressure switches or sensors. WHAT YOU NEED Before getting started, make sure you have: ALiEn2 or ALiEn2 Expert Plunger Lift Controller Pressure Transducer or Pressure Switch Install Pressure Device Pressure Switch Connections A…

ETC controllers are equipped with one or more digital outputs. These digital outputs can be turned on and off to signal to other systems, provide power to external devices, or run relays to turn higher power devices on and off.

There is a full simulator for the ALiEn2/ALiEn2 Expert plunger lift controller that is built from the software that runs in the controller. The simulator allows for: Training without have a physical controller Evaluating controller models and features Giving controller demos Testing Modbus (using TCP) Access to manuals and instruction…

Once an ALiEn2 controller is installed in the field and hooked up to the solar panel through the charger built into the controller, it will be automatically maintained. If however spare batteries or controllers with batteries are stored for more than a few months, the batteries should be charged periodically.